Some refrigerated trucks will be installed inside of the stock in the factory before the factory, what is the use of this?
What is a refrigerated truck Ventilation Groove?
The Ventilation Groove of the refrigerator is generally stainless steel or aluminum alloy. Its main role is to facilitate the circulation of air in the compartment to ensure an additional auxiliary measure in the temperature in the compartment.
For cold chain old drivers, the refrigerated car is installed aluminum alloy Ventilation Groove is required. If you run long-distance cold chains or transport with hot air, do not add ventilation, then the refrigerator can only exert 30% performance.
The role of refrigerated truck Ventilation Groove
The wind direction of the cold machine is generally in the top position of the front segment of the counter, what is the role of it, I can say a lot, I can’t remember, then I said if there is no ventilation Groove how to:
- When the goods are water, they cannot be discharged, and the cargo of the counter will rotten;
- When the goods are filled, the cold wind of the cold machine can only blow in the goods, the bottom of the car will slowly warming, there is a ventilator, the cold wind will blow to the back door of the counter, the cold wind is down, through the ventilation , Cold air is in a circulating state;
- If the goods carry a lot of hot air, the incubator is hard to volatilize, and the ventilation tank is used to take a lot of hot air, and it is best to set the ice into the intermediate ice, the effect is best.
Xiaobian summarizes the top three points, if there is no ventilation slot, then it is not easy to drain, the air is caught, and the hot air does not go. The following small series specifically tells you three points.
The ventilation slot can make the cold air cycle more smooth
The T-shaped tank of the refrigerator is installed on five sides. The design of the recess can protect the smooth air in the heat preservation of the refrigerator;
Better guarantees the freezing of the transportation items, and guarantees the temperature equalization in the vanity, the device has a ventilated car in the car, and it is not worried that the air is not smooth enough.
Virtual grooves can be drained
The ventilation slot is installed is not only the cold air circulation effect of the refrigerant but also allows the transportation of goods to not close the inner wall of the counter.
Another called water tank is also referred to as a water tank. When transporting those who have a heavyweight, ventilation can be used when the vent is used, and the water can be used in the water. It is not contaminated to the storage and discharges.
Ventilation slot can be used as an isolation track
In addition, the ventilation slot can sometimes be used as an isolation orbit to avoid transporting items directly to the wallet, which plays a certain protective role in transportation, preventing moisture pollution.
(Some of the drugs for transportation will have special requirements. It is also a hard specification that cannot be exposed to the gang wall. For example, it requires 5cm distance)
How much is the refrigerated truck Ventilation Groove?
Ventilation Groove is one of the selected configurations of the refrigerated truck, and the material of the ventilator is generally aluminum alloy.
The ventilation slot is based on the length of the carriage, usually $ 238 per meter.
The above is the role of the refrigerated truck installed Ventilation Groove, which is usually, and there will be more demand for large-scale refrigerated trucks to install Ventilation Groove;
Because the goods are relatively long, it is also a need for mandatory installation because of the relatively long time.